Honing Strop and Rouge
Now at this point you can check if the tin edge is gone by looking directly down at the blade edge. If that edge is has a fine shiny line along it you still have the tin edge. If the blade edge has no shine, you did it!
Newspaper Polishing
I am not sure that many use the newspaper any more. Originally it was the lead in the printers ink that acted as a rouging compound. I still do it because the ink does work as a polisher even though it no longer contains lead and the fine tooth of the paper gives that last little “lick” to the blade.
My father, who taught me how to carve, always checked the sharpness of the tool by holding up an edge of the newspaper with one hand. One corner of the paper hung free into the air. On that corner he would lay his knife and make a cut. If the paper “folded” under the knife edge it wasn’t sharp enough for him, because a razor edge will slice the paper without bending it.
As a beginning carver, this use to “discuss – discourage – depress” me. It seemed that as hard as I tried my paper always folded. But after just a few sessions of practicing sharpening I too could “slice the paper clean”.
With a new blade it might take several turns of sharpening to get that razor sharp edge you want. It seems to me that sharpening then using the knife for a little whittling, then sharpening again is what finally develops that perfect tool.
Sharpening Bench Knives and Chip Knives
Sharpening Round Gouge Honing Board
The Beginner’s Tool Kit
Your First Carving
Basics to Landscape Relief Carving
View Comments